Silverline Water Level 10m (633586)

Product Information

In case of water loss, refill and adjust the device. Colours on images on different devices may vary. We cannot guarantee an exact match of the colour to the product. We have a 30-day return policy, which means you have 30 days after receiving your item to request a return. Step 4 – Move to Level – Once it is settled you have achieved a level point between both ends of the tube, you can then move it up or down until the fluid meets the height required. The other end of the pipe will be at the same height. You can then place your mark The tube is then filled with water, except for a few inches at either end and they will both settle at the same level regardless of how close or far they are apart. Using water as a level in this manner has been done for many thousands of years and by many ancient civilizations including the Egyptians when building the pyramids so in terms of being a trustworthy method, it’s about as good and reliable as it gets.

Step 2 – Hold to Second Object – Holding your finger over the top of the tube, take the other end down to the object where you need to mark a level and hold in a "near enough" position towards the top of the object Before you can actually start levelling items with your water level you will first have to make it, if you’re not buying one. Follow the steps below to do so: But what if you need to level items such as fence posts over a long distance, or indeed around corners, obstacles or other structures. If you don’t have funds for an expensive laser level or tool that can do this this is where the water level comes into its own. Read on to find out about this fantastic tool. What is a Water Level?

270572 Water Tank Level Kit

To save the job of making your own, you can actually buy a pre-made water level from most DIY stores such as the one below. However it is likely that it will cost a bit more than making one yourself. Our collections by our couriers are happening as usual. As it stands, delivery times are not being affected too much. Please be aware though that Royal Mail and other couriers are sometimes prioritising essential items so please bear with us if your delivery takes slightly longer than expected. Step 2 – Prepare Water – Fill A suitable sized jug with water and add several drops of food colouring to to dye it. This will help to make it more visible in the tube

Step 5 – Mark Level Points – Before you start marking, the fluid in the pipe will not be flat, it will be concave as in the image below. You should agree with your help whether you are marking at the low point of the concave or the high point When it comes to making your own water level, the type of tube is of high importance. You will need to ensure that it’s the correct length for your needs, so 50 – 70 feet should suffice and a diameter of 8 – 10mm will give enough movement for the water and allow a level to be clearly seen. Hold the hose ends at the same height. Allow the water level to equilibrate freely. Mark both levels of the surface of water on the hose.Fresh water and waste tank level kit from CBE consisting of a tank test panel with coloured LED indicators, tank probes and wiring harness. This kit is ideal if you are retro-fitting a water tank or if you don’t have a level monitoring facility as part of your 12V control system. The LEDs light up when the test button is pressed and indicate FULL, 2/3, 1/3 and RESERVE. Put on the end plugs. They will prevent an outflow of water to the place of measurements. After reaching the measurement levels, remove the plugs. Note: If using with tanks of a shallower depth than 400mm, the probe can be cut down to suit as follows: The job of marking is best done between 2 people so that both ends can be marked, so bear this in mind.